digi dash into mk1 nova

[torquey]

Probably been covered numerous times, how hard to fit one into a mk1 nova dash? Also wiring is it hard or just a case of colour to colour? :thumb: thanks

[torquey]

Anyone help??

[Will F]

Easy to fit? Nope! Its easier to remove the entire dash and cut it bit by bit!
Wiring the same - nope again - but there are LOADS of diagrams about

[Andy]

Wiring is a piece of piss.Making it fit neatly is very very difficult.It took me ages and i was never happy with it so much that i ended up running a stihlsaw through my brown dash and fitting a mk2 one.

[torquey]

Great didn't think it would be easy. My dash is not the best anyways so might give it ago. Appreciate the help.

[Jack]

i ended up running a stihlsaw through my brown dash and fitting a mk2 one.
Jack approves of this

[Southie]

Get a spare mk1 dash and have a go, cut it to your liking then fibreglass all the fuckups, then get it flocked ;)

[torquey]

Good shout lol.

[dan23]

If I remember correct you can use part of a cavalier dash to fill the gap around the digi dash when it's fitted to the mk 1 dash

[brainsnova]

I done it with no filler or fibreglass, all I done was cut the dash to the same shape as the digi and mounted it from the back. You need to modify the air duct to the screen

[torquey]

Any pics of yours brains nova? ?

[NovalutionGSi]

I'd be interested in seeing that as well as that sounds like the route I might be taking on mine.

[millworm]

Take dash out 100% was a pain to do and ends up coming very close to the the demister ducting. I eventually went to a gsi dash as it's easier to take apart

[dan23]

If the dash mounts from the back how do you connect the wiring / plugs 

[millworm]

Do wiring before hand, then plug it in as you start putting the dash back in. It's a pain in the arse. There's a reason no one does it lol