How to run gt28

[carls nova sri]

Hi all I've bought a sx manifold an a gt28 turbo for my c20let but I'm stuck on plumbing it up because there's no nipples at all on it. I no I can run the bigger breather to a catch tank but what do I do with the small pipe that comes out of it to the amel valve an where does the other three small pipes go

[nova_stee]

The top threaded one is oil feed the lower two bolt one has a flange thats the oil return. Front water in from top of rad and the back ones the water return to header tank. As for amal valve one goes on actuator and u need to tap and fit a vacuem in cold side housing were boost pipe goes on for the other amal valve one

[carls nova sri]

Thanks mate do I leave the single outlet open on the amel valve because I got a pipe from rocker to catch tank. Also I got a hard plastic pipe that runs of a t-piece from fuel reg to turbo do I just do away with that pipe so fuel reg is one piece to inlet

[carls nova sri]

Anyone?

[TOZNOVA81]

I tagged you on the png facebook group mate about this, have a look dude :D

[carls nova sri]

I know I seen the notification come through but dropped my phone not long after you left an I've smashed the bottom in so can't use the bottom half lol so I'm on the iPad now but only got wifi an carnt remember my fb password. It's getting done tomorrow so will have a look thanks mate :thumb:

[TOZNOVA81]

No probs dude :)

[Benn]

Easier to pm me this thread link no? lol

[carls nova sri]

Drilled an tapped a thread for vacuume on cold side just need to know my last question

[carls nova sri]

Doesn't any body no

[Benn]

Sadly i dont. But if you have the amel valve plugged in it needs to be piped up.