Welding on new rear quarter.

[farleyj]

Hi guys, not been on for a while had other stuff going on so the nova took a backseat for a while. But the time has come go get cracking because I want it on the road for the summer and there's a lot to do. I'm going to be purchasing 2 new rear quarters and inner arches for my gsi. Pattern parts. In er arches ain't a problem but I'm wondering which way is best to go about fitting the rear quarters. Any advice would be very appreciated. Thanks

[totalnova]

I'm sure the was a build thread not long ago where some one was replacing the whole rear quarter panels on an Sr I think it was, just get the grinder out and the spot weld drill and attack the rust.

[matty gte]

Best way to do your quarter offer it up and mark roughly where it wants to be cut start at the bottom because use your sill as a start point then the more you cut out the more it fits etc on the way up till you get to b +c pill then lots of mole grips lol and cut it in hope that helps