View Full Version : Roll cage decisions
Looking at buying a full cage from demon tweeks. I have two options omp or sparco I'm unsure if I have to cut the dash does anyone know anything about these cages thanks in advance dan :thumb:
DaveMarshall
22-12-15, 06:36 AM
Not had any experience of either cage but there are a few others you can try also.
Safety Devices
Roll Centre
Fabricage
Custom Cages
might be worth contacting them as they often can supply a cage to your specification.
Dave.
I would be trying some of the above companies first also. It would be better if you did have to cut the dash and it stayed tight to the A pillar.
novatracker
01-01-16, 10:43 PM
has custom cages not gone under? i remeber hearing that lately
mk1nova_rich
01-01-16, 11:08 PM
OMP cages are shite
bazzap8389
02-01-16, 10:04 AM
has custom cages not gone under? i remeber hearing that lately
Not that I'm aware of, I got a letter from them just last week saying they're putting their prices up though. Not sure why they had to send a letter about it lol
millworm
02-01-16, 10:45 AM
Omp misses the dash, personally ild rather have one that goes through and across the bulkhead
mk1nova_rich
02-01-16, 11:32 AM
Omp misses the dash, personally ild rather have one that goes through and across the bulkhead
And most OMP cages I have seen don't go to the rear arches either
Lol may aswell use waste pipe then sprayed black
has custom cages not gone under? i remeber hearing that lately
Nope. There was a LOT more to that Facebook story then what that Evo owner said....
Mainly the shit welding that WASN'T done by CC.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.