PDA

View Full Version : Some guidance !


phunkynova
08-10-15, 06:51 PM
Okay as some know the engine in my rally car engine went bang send a con-rod through the block and the after a rebuild the camshaft snapped and caused a lot of damage my money is now running out so NO BIG EXPENSIVE engine rebuild is possible, I have a spare camshaft and the parts to fix the head but the pistons in the engine took a far hit from the valves could I use these again ?

http://i995.photobucket.com/albums/af71/phunkferret/20150928_143935_zps0alhn8yo.jpg

http://i995.photobucket.com/albums/af71/phunkferret/20150928_144050_zpstvu9nzfk.jpg

http://i995.photobucket.com/albums/af71/phunkferret/20150928_144146_zps7cs01qaa.jpg



Or I could use the 3 of the pistons out of the other engine ( 1 shot out of the block) with new big end shell but not piston rings as they are to much at over £35 per piston.
mowgli
08-10-15, 08:18 PM
Seriously, where are you getting your rings from? Can't any of your Czech friends source any cheaper ones?

Personally, my view is that you shouldn't trust the damaged pistons. Are 1400 bottom ends rare in Germany?
Andy
08-10-15, 08:25 PM
I paid 60quid for a full set of rings.the top quality ones too.
re the pistons....i wouldnt entertain the thought of using them.
phunkynova
08-10-15, 08:43 PM
I paid 60quid for a full set of rings.the top quality ones too.
re the pistons....i wouldnt entertain the thought of using them.

I must use at lease one as I have only 3 other good ones
meritlover
08-10-15, 10:07 PM
Yes. The crowns are fine. As rong as the lands are ok and the rings dont bind then there will be no difference.
Will F
09-10-15, 08:46 AM
No chance - if if were a road car then maybe I would, but due to their use, I would use new or some really good second hand ones...

I had a similar situation (not as bad as yours) and the piston lasted about 800 road miles before it cracked and ate the bore...
Andy
09-10-15, 12:22 PM
For what they cost it simply isnt worth it.
phunkynova
10-10-15, 04:14 PM
Some mixed opinions on this one !
Dose any one out there have one good used or new 1.4 NV or NZ piston and con-rod that I could buy from you ?.
If I can can get one then I'd be able to make up a set of 4 !.
phunkynova
15-10-15, 05:47 PM
Up-date on this I have now got a full set of new pistons and piston rings but will the original con-rods be okay to use ?.
meritlover
15-10-15, 07:33 PM
If you've measured them and they're straight then they are fine.
Andy
15-10-15, 11:10 PM
If you can be sure theyre straight and not fractured then they will be fine.