View Full Version : Servo connection to inlet manifold thread.
steg1970
22-03-15, 08:20 PM
Can anyone tell me the thread size in the inlet manifold at the take off for the brake servo.
I know this, as I had to drill and tap my throttle bodies to fit a servo vacuum feed...........
ill have a look tomorrow for the tap, it might be in my WIP I'll have a look now and edit it in if I can find it!!
EDIT :- sorry mate I ditched the original fitting and used an M12x1.5 to barb fitting for my take off
http://i27.photobucket.com/albums/c175/grahampointing/2C781A42-C503-4866-BB29-46F8A7258D78.jpg (http://s27.photobucket.com/user/grahampointing/media/2C781A42-C503-4866-BB29-46F8A7258D78.jpg.html)
steg1970
22-03-15, 10:49 PM
I know this, as I had to drill and tap my throttle bodies to fit a servo vacuum feed...........
ill have a look tomorrow for the tap, it might be in my WIP I'll have a look now and edit it in if I can find it!!
EDIT :- sorry mate I ditched the original fitting and used an M12x1.5 to barb fitting for my take off
http://i27.photobucket.com/albums/c175/grahampointing/2C781A42-C503-4866-BB29-46F8A7258D78.jpg (http://s27.photobucket.com/user/grahampointing/media/2C781A42-C503-4866-BB29-46F8A7258D78.jpg.html)
Thanks anyway.
I've just found the little double ended bit that goes into the manifold, I'll see if I can measure the thread tomorrow and get back to you!!
steg1970
23-03-15, 08:31 AM
I've just found the little double ended bit that goes into the manifold, I'll see if I can measure the thread tomorrow and get back to you!!
Magic, thanks.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.