How to remove doors?????

[Walshysr]

Is there a easy way to remove the pins from the door hinges? Or even a good way really struggling with this and so tempted to just cut them off then try and find new doors hahha

[therealnovaboy]

Is there a easy way to remove the pins from the door hinges?

no

you can either buy a door pin removal tool or find a punch that fits the pins. the bottom one is almost impossible without the proper tool. its not easy unless you don't need the door in one piece or the car in one piece. then yu can cut off the door and hammer the pins out on the bench.

soak them in WD40. knock the bottom one up and the top one down. its sometimes best knocking them the opposite from this just to get them moving. also don't take one all the way out without the other or the hinge twists and it will jam.

the bonnet stay is the same OD as the pins so makes a handy drift. however if they are really tight it probably wont work.

[Walshysr]

Hahaha cheers mate I'll keep going at it hahah snapped two screw drivers upto now hahha

[brucer]

http://www.pngclub.com/forum/showthread.php?140696-*HOW-TO*-remove-doors&highlight=

[Walshysr]

Thanks brucer

[josh-sri]

Great guide Bruce was just about to ask the same question myself, shame I don't have a bonnet stay!

[Walshysr]

Just cut my bonnet stay up and took at most 10 mins to remove doors. Png best forum by far and some great people thank you very much!! Just need to find a new bonnet stay hahah

[conza123]

Tx auto sport do nice new polished ones
http://www.txautosport.co.uk/vauxhall-nova-corsa-polished-stainless-steel-bonnet-stay-83-p.asp

[Walshysr]

Cheers conza I'll get one ordered :thumb: