Will F
22-02-15, 08:16 PM
This engine has not been driven since its had a £3000 rebuild. It's been run on a dyno and then fired up in a car to make sure it was ready for a mapping session. That's it!
it can be bought as either a complete running engine or as a tall engine, depending in what your requirements are.
spec
new 87mm Wossner pistons
bored and decked block
new pec steel rods
arp head studs and rod bolts
z20leh steel head gasket, 8.5:1 cr
c20xe cams
new kkk hybrid turbo last year
dta s40 engines management system
rc 750 injectors
fuel lab regulator
it was mapped in Kent in 2011 at 327 bhp and 300 lb ft torque
its since been rebuilt with bigger Pistons etc, so should be good for more
its got a running in map on there for now, so will need a session when it's run in
£2200
i can can sell the tall engine for 1600 separately.
can post for £70
it can be bought as either a complete running engine or as a tall engine, depending in what your requirements are.
spec
new 87mm Wossner pistons
bored and decked block
new pec steel rods
arp head studs and rod bolts
z20leh steel head gasket, 8.5:1 cr
c20xe cams
new kkk hybrid turbo last year
dta s40 engines management system
rc 750 injectors
fuel lab regulator
it was mapped in Kent in 2011 at 327 bhp and 300 lb ft torque
its since been rebuilt with bigger Pistons etc, so should be good for more
its got a running in map on there for now, so will need a session when it's run in
£2200
i can can sell the tall engine for 1600 separately.
can post for £70