c14se complete top end, head, inlet, loom + ecu

[XEjames]

Hi all
Picked up a c14nz corsa for a work runaround + want to go from spi to mpi so need head, inlet, loom + ecu

Let me know
Cheers
James

[jimbob-mcgrew]

just a quick heads up, incase you didnt know - the pistons in the NZ are a smidge shallower than the SE, so the compression ratio will be 9.4 instead of 10, not a major difference tho, only a couple horse.

it should convert over no probs tho. depending on whats currently on the NZ block, you might need a bottom crank pulley to go with the top end bits. (trigger for crank sensor)

you might need an mpi fuel pump too, but not sure

[XEjames]

Cheers for the info jimbob, yes i knew the CR difference but i plan on doing a turbo conversion anyway, ive had c20xe + c20let novas so now want a small block
Yes ill be using an external pump, will go new as cheap enough, didnt know about pulleys though, cheers for the heads up

Still looking people, or I would also strongly consider an x16xe :-)

cheers

[novarally]

I've got these if of any interest to you;

8v Corsa SRi 1400cc 8v engine

1400cc 16v X14XE engine

1600cc 16v C16XE engine with steel rods and Omega forged pistons

[turbo-boy]

Much for the sri 1.4 8v head?

[XEjames]

Will e-mail you colin, cheers :-)

[XEjames]

Very much thankyou to colin, looks like im all sorted apart from a loom + ecu
many thanks

[novarally]

Very much thankyou to colin, looks like im all sorted apart from a loom + ecu
many thanks

Do you still want this engine James?

I thought you wanted to collect it tomorrow, but I've not heard from you?

[ben doodar]

Got a c14se loom and ecu here. If your still in need of them pm me.