urgent torque settings for 1300 head

[pottersrebel]

as above does anyone know the initial and secondary settings for torqueing up a 1300 head

[millworm]

25nm then 60 degrees x3

[craig green]

or 'FT' if you are a pikey.

[millworm]

just get the gun on there and go for gold

[craig green]

Lol

[pottersrebel]

forgive me for being dumb but what do u mean 60 degrees x3. appreciate the help :thumb:

[millworm]

do all of them to 25 nm
then turn each 60 degrees 3 times
litrally have to turn it to the angle of 60 degrees

[pottersrebel]

thanks millworm

[Andy]

You know the tightening sequence right?

[millworm]

no probs mate

[pottersrebel]

You know the tightening sequence right? its for a mate I was asked for torque settings not sequence lol I assumed he knew but what is the sequence and ill text him just in case

[jimbob-mcgrew]

i did one a few months back (13S)
i still have the elring instructions.

25 nm
60 degrees
60 degrees
30 degrees

run for 15 mins (upto temp)

30 degrees

i dont know if its different for different brands, but that was elring instructions, and i used elring gasket, as well as elring head bolts.
and has this layout in the instructions, for bolt tightening sequence.

http://petrila.org/repair/2/206/images/b/b1dk00sc.gif