Digi dash help

[Nutty Nova]

Hey guys have finally got round to looking at
Fitting my digi dash and have a couple of questions.

have noticed a damaged wire on the back would this cause any problems?

also believe I have the transducer for it but it has a speedo cable centre attached that seems permanently attached.
do I have to fit the speedo cable also aswell as wiring from the plug to the dash.

http://i221.photobucket.com/albums/dd121/Pownabown/model%20car/Nova%20Fun%20Project/7D154940-081C-4A95-BFF6-EA6E3F8AD829_zpsi1df4lkv.jpg (http://s221.photobucket.com/user/Pownabown/media/model%20car/Nova%20Fun%20Project/7D154940-081C-4A95-BFF6-EA6E3F8AD829_zpsi1df4lkv.jpg.html)

http://i221.photobucket.com/albums/dd121/Pownabown/model%20car/Nova%20Fun%20Project/FEDF51B4-2EDB-4007-8242-DEDB593B7AE0_zpsnfacjojn.jpg (http://s221.photobucket.com/user/Pownabown/media/model%20car/Nova%20Fun%20Project/FEDF51B4-2EDB-4007-8242-DEDB593B7AE0_zpsnfacjojn.jpg.html)

any of your help is much appreciated

[dgbnova#1]

The transducer is prob of Sri nova it will be fine without the cable

get a close up of the damaged circuit board but fire up the clocks and see what is working

[Nutty Nova]

OK thanks will do that, I have a spare set of digi clocks without the perspex face will check to see if the circuit board is ok on that one

You maybe right about it being a transducer from a nova spin, as it is marked up AA whereas ive seen most people use AH or AK transducers. Is it likely to still work with this?

[dgbnova#1]

Yes it will be fine