Johnny A
09-06-14, 11:10 PM
Here I have a pair of JDM bearing top mounts originally for aftermarket coilovers on a Toyota Starlet.
https://scontent-b-cdg.xx.fbcdn.net/hphotos-xpf1/t1.0-9/10301053_10154166560270214_1152184401906794013_n.j pg
These are compatible with aftermarket Nova suspension as pictured here (but not bolted down) to my new Gaz coilovers.
https://fbcdn-sphotos-e-a.akamaihd.net/hphotos-ak-xfp1/t1.0-9/10457774_10154166559900214_1852501625192419235_n.j pg
https://fbcdn-sphotos-a-a.akamaihd.net/hphotos-ak-xpa1/t1.0-9/10334259_10154166560100214_7662382826917651613_n.j pg
They come with 2 of the little inserts to make sure they are a secure fit, all that is needed is a washer and the top nuts (original nova M12x1.25 nylock nuts are perfect)
https://fbcdn-sphotos-g-a.akamaihd.net/hphotos-ak-xfa1/t1.0-9/10468547_10154166559980214_6955099658492037645_n.j pg
These are not a direct fit! You will need to remove two of the four threaded rods on the top mounts and elongate the holes on the Nova to get them to fit but these offer more negative camber and a much easier way of fine-tuning than anything else offered on the market.
Also due to the bearing being almost flush with the mount there is no need to cut away at the centre hole on the turret if running full negative camber!
These could do with a good clean but otherwise work and adjust fine, the bearings are nice and tight and move freely.
£30 + postage or can bring to Billing.
https://scontent-b-cdg.xx.fbcdn.net/hphotos-xpf1/t1.0-9/10301053_10154166560270214_1152184401906794013_n.j pg
These are compatible with aftermarket Nova suspension as pictured here (but not bolted down) to my new Gaz coilovers.
https://fbcdn-sphotos-e-a.akamaihd.net/hphotos-ak-xfp1/t1.0-9/10457774_10154166559900214_1852501625192419235_n.j pg
https://fbcdn-sphotos-a-a.akamaihd.net/hphotos-ak-xpa1/t1.0-9/10334259_10154166560100214_7662382826917651613_n.j pg
They come with 2 of the little inserts to make sure they are a secure fit, all that is needed is a washer and the top nuts (original nova M12x1.25 nylock nuts are perfect)
https://fbcdn-sphotos-g-a.akamaihd.net/hphotos-ak-xfa1/t1.0-9/10468547_10154166559980214_6955099658492037645_n.j pg
These are not a direct fit! You will need to remove two of the four threaded rods on the top mounts and elongate the holes on the Nova to get them to fit but these offer more negative camber and a much easier way of fine-tuning than anything else offered on the market.
Also due to the bearing being almost flush with the mount there is no need to cut away at the centre hole on the turret if running full negative camber!
These could do with a good clean but otherwise work and adjust fine, the bearings are nice and tight and move freely.
£30 + postage or can bring to Billing.