Wilwood pad rattle/clatter

[Iain]

I have Wilwood Dynalite old cast alloy calipers, single split pin through the top of the pad to keep it in place

The pad clatter/rattle is immense when driving on the road, really loud and annoying

It was bad before, now I've fitted some pads where someone has drilled out the top split pin hole slightly so it's even worse!

Anyone know of easy or off the shelf ways of stopping it?

[Stuart]

http://www.elise-shop.com/anti-rattle-brakepad-buffers-elise-exige-340r-vx220-all-models-p-65.html

[Iain]

Look like a potential solution, will reseach where they fit!

I was looking for your usual type of clip on the top or down one side of the pad to hold it in place

[Stuart]

they fit where the short edges of the pads would rattle against the edges of the calipers (top and bottom)

[Iain]

Winner, could do the trick nicely, ordered.

[Iain]

I fitted those little pads and also reduced the size of the hole in the pad that the split pin goes through so it can move less on that and it's lovely and quiet now.

[Stuart]

:thumb: