PDA

View Full Version : Sri sun visor wiring.......



Damo
29-05-14, 10:21 PM
Hi guys how are the sri sunvisir lights wired in? Are they wired to the interior light or do they have a permanant feed so they work all the time?.

Damo.

Sent from my GT-N7100 using Tapatalk

w88rdy
29-05-14, 10:23 PM
Just a switched live Damo so they work when ignitions on would be fine

Damo
29-05-14, 10:33 PM
Sound mate al get making a loom up then ;).

Sent from my GT-N7100 using Tapatalk

Spudly
30-05-14, 05:41 PM
In the OE vaux wiring, they take a power from the interior light (so theyre always live but closing the flap over the mirror turns them off) and they earth down near the fusebox, when ive retrofitted them before, i always just earth them where one of the visors screws into the roof itself, few min job to install, tricky bit is running the wiring through the roof to the middle lol

Damo
30-05-14, 09:44 PM
In the OE vaux wiring, they take a power from the interior light (so theyre always live but closing the flap over the mirror turns them off) and they earth down near the fusebox, when ive retrofitted them before, i always just earth them where one of the visors screws into the roof itself, few min job to install, tricky bit is running the wiring through the roof to the middle lol

Spud, will wiring them to the interior light not make them only work when the lights on or doors are open?..

damo.

dgbnova#1
30-05-14, 10:23 PM
Wire to the perm live/ignition live at the light they switch earth not live when the door opens

Southie
30-05-14, 11:02 PM
Out of interest as I never did this mod but did you have to pull down the headlining to fit the wiring? Probably a daft question.

dgbnova#1
30-05-14, 11:10 PM
No you can fish the wires across it's not that far to feed the cables

Southie
30-05-14, 11:14 PM
I'll never be doing it now but maybe will help if someone searches in the future ;)

Spudly
01-06-14, 01:47 PM
I used to use the bendy flexy stuff that used to hold net curtains up, feed that through from the sunvisor end, tape the wire to it then pull back through!

And no, the interior light is perm live so the sunvisors will always be powered, opening the door earths the circuit and turns the light on, because the sunvisor loom has its own earth, it only needs the power feed, trust me thats how theyre originally wired up:thumb: