Cam pulley

[bighed]

Firstly I would just like to say I've spoken to 40p (seller) and he doesn't mind me putting this up.
Ollie has been very helpful, cheers again! :thumb:

I bought this this about a week ago with a Kent cam. I never noticed this until properly looking at it the day after. Kent on left. Standard on right.


http://i142.photobucket.com/albums/r116/bighed123/20140506_154748_zpsa0bbd2cc.jpg

This is the one side

http://i142.photobucket.com/albums/r116/bighed123/20140506_155338_zps03ec1ec5.jpg

and the other

http://i142.photobucket.com/albums/r116/bighed123/20140506_155246_zps08ec5c3d.jpg

It almost looks like a thinner cam belt has been used to me as when I put my 15mm wide belt on it hangs over the side.


What would you guys do?

[bighed]

http://i142.photobucket.com/albums/r116/bighed123/Mobile%20Uploads/20140506_160751_zpsbb40esgs.jpg (http://s142.photobucket.com/user/bighed123/media/Mobile%20Uploads/20140506_160751_zpsbb40esgs.jpg.html)

[meritlover]

very nice

[dgbnova#1]

The vernier pully is worn I take it on them photos prob look at getting it re machined will ask Bazzap to have a look at it as he may know what's involved in getting that done or it's a case of grtting another one

[bighed]

It's gonna work out cheaper to get another I bet....

[8valve-craig]

If that's as worn as it looks in the photo I would bin it and buy a new one.

[dgbnova#1]

Would you say that's from slack or tight belt skinny one or wrong spacing as I've not seen one like it before well not on an 8v motor

[BRoadGhost]

Yes it's wear

[mowgli]

it looks knackered, I wouldn't use it on mine.