View Full Version : Door pin remover
mikey093
17-03-14, 11:32 AM
I'm finding a bit hard to remove my door pins so I am going to get the tool. Anyone know the right size I will need to do the job.
Thanks in advance
torquey
17-03-14, 11:53 AM
Use a bonnet stay cut down thats what i used to remove the pins.
brainsnova
17-03-14, 11:56 AM
When you replace them use the later pins a bit like a golf t shape
dgbnova#1
17-03-14, 12:14 PM
It's an 8mm pin to remove and as stated the. Cav calibre plus others have a flared end far easyer to remove if your replacing the pins
load of wd40 soaking overnight if possable longer
tge bonnet stay is the same diameter so an ideal punch to use but if ure saveing the doors the bottom hinge needs knocking up not down so knock the pin down a little to listen it then use the tool to knock it upwards
mikey093
17-03-14, 12:19 PM
Will have ago with the stay and look for new pins thanks. Il chop the top and bottom section out too so I have better access
dgbnova#1
17-03-14, 12:27 PM
If ure binning the doors ye just chop them out and bend out then knock the pins down simples !
mikey093
17-03-14, 12:50 PM
Are the pins from cav the same size as originals
dgbnova#1
17-03-14, 01:26 PM
Yes cav 3 pins fit the same
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.