Chassis Measurement

[rich a]

Does anyone know what the measurement between chassis legs right at the end, inside to inside where the front panel joins. Mine is 820mm just want to check before I weld the new front panel in cheers for any help :confused:

[8valve-craig]

I make it 825mm right at the bottom.

[rich a]

cheers craig how confident r u your chassis is bang on. the reason I ask is 820 seems an odd number 800 would make more sence ?

[bazzap8389]

I'd say there's more chance if it being between 820-825, if Craig gets 825 and you get 820 it's not going to be 800, that's an inch of a difference from Craig's size.

[bazil]

Check the link in my sig,

[8valve-craig]

You aren't measuring off a chassis plating kit are you? If i measure off mine i get 820mm ish.

100% confident mine is bang on. Its all original.

[rich a]

Check the link in my sig,

cheers bazil from your link it looks like 660 is the measurement between the tie bar mounting centres in need distance between legs.

bloody good point craig it does have a plating kit if I go down the bottom of the legs its nearer 820 cheers for the help

[bazil]

Its measurement b your looking for, from Engine mount bolt hole to the n/s leg

[rich a]

Another question does any one know the size length and thread the bolts that go through the arb brackets as mine had to be cut off ?

[rich a]

Its measurement b your looking for, from Engine mount bolt hole to the n/s leg

My bad bazil was looking at measurement a lol