Anyone looking for abit of work?

[Daveo]

Hi all, I would like to offer someone a couple of days work.

I'm looking at doing an engine conversion but my knowledge alone isn't enough to complete the whole thing.

And it would be a great chance to meet somebody off here.

I need someone who can remove and fit a new engine to a competent level.
Someone who is fairly local to me and who would have sufficient tools, I have most required but am probably missing some.

I will pay in cash and tea/biscuits included.

If you know someone who may be Interested please pass on the word.

Thanks

[Dan Stanley]

Good luck with that. Sounds like an honest appeal and most people on here like to help out anyway. Hope it goes well

[conza123]

it mite help if you list exactly what you want doing ie what engine you wonna put in what engines in there to begin with etc,

what parts you got to go with engine etc

hope you find help

[millworm]

Got someone who would be more than competent and is local too will have a word with him tomorrow

[Daveo]

it mite help if you list exactly what you want doing ie what engine you wonna put in what engines in there to begin with etc,

what parts you got to go with engine etc



Good point, it will be a e16se with an f15 box into my 1L saloon. I will have all the parts required would just need some extra knowledge.

[Daveo]

Got someone who would be more than competent and is local too will have a word with him tomorrow

Ok mate, nice one

[jimbob-mcgrew]

got an injection petrol tank ?

cant remember if you need driveshafts for an F15 ?

[Daveo]

got an injection petrol tank ?

cant remember if you need driveshafts for an F15 ?

Not yet but I will get one from a gsi etc.

[John]

the 3 door hatch gsi tank won't fit your saloon. You need to find an spi 5door hatch/4door saloon tank, and fit a mpi internal pump.

[Daveo]

the 3 door hatch gsi tank won't fit your saloon. You need to find an spi 5door hatch/4door saloon tank, and fit a mpi internal pump.

Thanks!

[Andy]

Or keep your standard tank,fit an external pump and swirl pot.
Decent tanks are hard to find these days.

[Daveo]

Where would be the best place for the swirl pot? And what pump?

[Andy]

nova gte pump.
Swirl pots are on ebay.
I actually ran my 2.0 without a swirl pot using a 1.2 carb tank and gte pump.Its fine until you get to 1/4 tank and below when taking left hand bends fast...

[Timmy]

Drive shafts should be fine, unless 1lt are different.

[Daveo]

Drive shafts should be fine, unless 1lt are different.

I believe the drive shafts should be fine, someone please correct me if I'm wrong