eds phase 2 boost set up

[torquey]

Iam after some advice I've speced my let for phase 2 now got my ecu and want to set the boost up iam wanting 14 psi I've got a mbc what's best way of achieving this I been told I need wideband but surely people have done it without but don't want to cause any damage without it being set up right any help would be great !

[Benn]

Winding the nut/arm in on the actuator will increase the boost, you'll have to wind the nut in a bit then try it, wind it in the try. Not sure on mbcs as i've never used one, but that's how i set my boost up.
But isn't 14 a bit low? I'm std and i'm sure mine over boosts to 13psi and holds 11.

[torquey]

Right I have about 12 mm of thread showing on actuator wanting to use mbc to set psi at a set figure no overboost is urs phase 2 ben? Are you using wideband ? Thanks .

[Benn]

I have 12mm thread showing, whichs holds 11 psi, running a standard ecu/chip set.
Standard boost control. No wideband yet.

[torquey]

Right maybe something wrong with mine then cos iam not getting that much boost its still running amal valve was thinking it may be fecked. I've got a forge actuator on aswell .

[Benn]

Wind the nut in a few turns. Think you need the gate to open later..

[torquey]

Ok will give it a go thanks Ben

[brucer]

benn, i think overboost is 18psi and holds 14.

[Benn]

Ok?