marc69
11-05-13, 01:45 PM
I was losing fluid from a burst seal on a rear cylinder on my SR so I put on a new one, it doesn't seem to sit completely central on the front piston. Here are two pics.
http://i988.photobucket.com/albums/af5/69marc/IMAG0232_zps109ac9b4.jpg
I have driven it and it seems ok but will it cause a problem in time or should it be ok?
http://i988.photobucket.com/albums/af5/69marc/IMAG0233_zps2c381b53.jpg
If it is a hassle, I could just put a washer or two behine the bolt bit to even it out?
Thanks
http://i988.photobucket.com/albums/af5/69marc/IMAG0232_zps109ac9b4.jpg
I have driven it and it seems ok but will it cause a problem in time or should it be ok?
http://i988.photobucket.com/albums/af5/69marc/IMAG0233_zps2c381b53.jpg
If it is a hassle, I could just put a washer or two behine the bolt bit to even it out?
Thanks