View Full Version : rolling arches
Acerliam
02-05-13, 09:50 PM
I just wondering is this a good idea or not as im looking at getting a ultra low Gaz coilover kit and I'll need to roll my arches to go lower without catching, Also anyone know where to get it done professional and does a good job
Thanks
edkillick
03-05-13, 06:10 PM
If your arches aren't rusty and look pretty solid then give it a go, you can do it with a heat gun and a rubber mallet. Takes a while though. Baring in mind that the paint may crack after you've rolled them so make sure you've got some filler or some touch up paint to cover it up. Hope this helps
smart8887
11-05-13, 10:49 PM
I'm running Avo Coilovers I had to run 185s on rear as the normal 195s where to wide:cry: ,fit a treat now:) you can trim the arch abit to, what i have done on mine.
staggy_gsi
11-05-13, 11:07 PM
You can hire a proper arch roller, theres a place who list them on ebay
Acerliam
12-05-13, 12:31 AM
Im all sorted now
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.