Door Hinge Pin Size

[leefowler]

As above does any one know the size of the hinge pin so as I can purchase a removal tool.

Thanks

Lee

[Graeme]

8mm diameter

[Danny mul]

I always use 8mm threaded rod to remove them.
Can buy a meter length in any hardware store.
Its handy as you can bend it away from the door to stop it scratching your paint

[kevster]

Have you tried CPA I got a kit from them a few years back . Hope this helps

[Graeme]

Just use a bonnet stay with the ends cut off, perfect size

[dan23]

as already said piece of bonnet stay
cut the end off an old screwdriver an weld it to it then you can give the handle a good whack

[mowgli]

or buy a universal pin removal tool from a motor factors, it will have the right size bit in it. also remember to jack up the outer end of the door a little (use a rag on top of the jack to protect it) this is cos the pins always wear in an offset & if you don't, they are a bitch to remove

[Jeff16v]

Get a long 13mm bolt and grind the thread off,

[brucer]

http://www.pngclub.com/forum/showthread.php?140696-*HOW-TO*-remove-doors