View Full Version : Big block cv spacers?
Are the larger washers used to space the cv joint off the hub carrier there to prevent the cv joint touching? And what size is it internally and externally?
Dan
on mine i just use x2 of the hub nut washers? and a smaller pin in the hole? ive used mine for over 12months with no issues?
The washer he's talking about goes between the CV and the rear face of the bearing. Yes I believe it's meant to stop the CV binding against the knuckle, but IMO its worth a trial fit to see if they bind or not as mine seem fine without the spacer.
I have had a trial and they seem to just touch. I just wondered what people actually used
Oooo mine fit nicely then lol i dont run rear washers
davidfox280585
27-01-13, 09:16 PM
if it hs abs rings which are touching then chisel them off there just sweated on
hope this helps
Another vote for knocking the abs ring off and they clear
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.