View Full Version : Looking at a Nova Redtop tomorrow
Can anyone give me some tips about what to look out for? I had a Nova years back and know rust is an issue but as far as the conversion goes are there any bits I should be looking for that may not be obvious?
Any advice is much appreciated :thumb:
loads lol, stitch welded? Shafts are they GTE, Big Block or welded jobbys? Exhaust? - Decent welding job or is it blowing? Suspension? Just uprated springs are no good ideally a full setup. Brakes? - Minimum of 2.0 256mm. Engine mounts? Wiring and pipework neat? just anything that looks out of place
make sure its registered as one on the log book for insurance purposes
Check it isnt out of date, sniff test will soon show.
loads lol, stitch welded? Shafts are they GTE, Big Block or welded jobbys? Exhaust? - Decent welding job or is it blowing? Suspension? Just uprated springs are no good ideally a full setup. Brakes? - Minimum of 2.0 256mm. Engine mounts? Wiring and pipework neat? just anything that looks out of place
Thanks for that
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.