therealnovaboy
29-12-12, 11:10 PM
If Im quiet over the new year Im thinking about using the lathe at work to turn some top mount spacers so I can run my eccentric top mounts with my spax RSX shocks.
Problem is I wont be home to get any measurements. I Need the diameter of the top of the shock spindle (bit under the thread), the distance from the shoulder of the spindle to the bottom of the thread and the leangth of the threaded part.
Im pretty sure the ID of the top mount bearing is 19.8mm and 25mm deep but if someone could confirm this. I have compbrake top mounts.
Also does the top spacer need to be threaded? could i use the nylock nut to clamp the two spacers together in the bearing? I suppose it would be easier to get a tight fit to the shock if it was threaded. do you need the nylock nut as well to lock top the spacer
Any help would be great but understand if you cannot be bothered measuring stuff.
Problem is I wont be home to get any measurements. I Need the diameter of the top of the shock spindle (bit under the thread), the distance from the shoulder of the spindle to the bottom of the thread and the leangth of the threaded part.
Im pretty sure the ID of the top mount bearing is 19.8mm and 25mm deep but if someone could confirm this. I have compbrake top mounts.
Also does the top spacer need to be threaded? could i use the nylock nut to clamp the two spacers together in the bearing? I suppose it would be easier to get a tight fit to the shock if it was threaded. do you need the nylock nut as well to lock top the spacer
Any help would be great but understand if you cannot be bothered measuring stuff.