anti roll bar

[silk violet]

Hi there i have a nova gsi with 20xe conversion and i am rebuiding it and almost done... And have found my anti roll bar which was taken off along time ago and am wondering if i should put it back on as i have just repainted it and found all the bits for it....??? any thoughts peeps much help would be appreciated....? :thumb:

[paul james]

Some people like to have the bar, some don't. I don't think there is a definitive answer (its been covered many times before) as its down to personal preference. Since you have it already, why not try the car with it off and then on and see if you notice\appreciate the difference. It doesn't take long to fit, so give it a try.

[16v Nova Kev]

Personally I would use it

[silk violet]

Cheers

[Edd]

If you like understeer leave if off, if you don't fit it

I personally thought my XE was dangerous without

[Mieran]

All depends on your suspension setup and spring rates

[Stuart]

Try it, if you dislike it then you are a man.

[GRUNT 16V]

I fitted mine to my c20xe nova after about 6 months of driving without it,I left it on for a road test the took it off as soon after fitting it !! about 1 hour

[Iain]

After testing around Cadwell Park on my Nova, I left mine on.

[silk violet]

I tried placing it up to the tie bars today and and the bar touches the exhaust down pipe and blocks touching the drivers tie road about an inch at the front corner.... any suggestions..??

[MK999]

Check IaiaiaiaiianImABigGayAndLikeUndersteeringRubberARB ****e's thread, he had to use a fair amount of spacers to clear his system.

[meritlover]

anti roll bars generally result in less grip

[Iain]

Check IaiaiaiaiianImABigGayAndLikeUndersteeringRubberARB ****e's thread, he had to use a fair amount of spacers to clear his system.

Proper ARB lowering blocks and a selection of universal 8mm ID shim units below that to make it fit.