dc1984
28-11-12, 03:34 PM
Hi folks,
i`ve finally got my finger out and started to work on my nova again after 15 months:roll:
There are a few small problems i`ve come across so far, mostly down to forgetting where bits go and misplacing / loosing parts when i moved units.
1. On the side of the xe inlet manifold there is a hole thats threaded, what goes there?
2. Under the inlet there is an outlet for a hose, does the icv go onto it?
3. I have managed to loose one of the rear gearbox to floor bolts, are they stocked by vauxhall?
4. I bought solid mounts ages ago but the front drivers side one is not threaded like the original one, is it just a case of drilling the chassis leg and fixing it from the wheel arch using a long bolt and nut?
5. The fuel line as it leaves / enters the tank requires a really tight bend in a rubber pipe, can these be bought from vauxhall?
I hope i`ve explained these in a way that makes sense.
thanks in advance folks:thumb:.
David.
i`ve finally got my finger out and started to work on my nova again after 15 months:roll:
There are a few small problems i`ve come across so far, mostly down to forgetting where bits go and misplacing / loosing parts when i moved units.
1. On the side of the xe inlet manifold there is a hole thats threaded, what goes there?
2. Under the inlet there is an outlet for a hose, does the icv go onto it?
3. I have managed to loose one of the rear gearbox to floor bolts, are they stocked by vauxhall?
4. I bought solid mounts ages ago but the front drivers side one is not threaded like the original one, is it just a case of drilling the chassis leg and fixing it from the wheel arch using a long bolt and nut?
5. The fuel line as it leaves / enters the tank requires a really tight bend in a rubber pipe, can these be bought from vauxhall?
I hope i`ve explained these in a way that makes sense.
thanks in advance folks:thumb:.
David.