PDA

View Full Version : *HOW TO* Measurements for reproducing rear mudflap support brackets



Calamity Josh
28-11-12, 03:50 PM
Thought i'd take one of my mudflaps (and supports) and take some pictures that show measurements for those who are missing some, so it would be simple to make a set. :thumb:
some general pictures:
http://i1084.photobucket.com/albums/j404/CalamityJosh/Braintree-20121127-03487.jpg
http://i1084.photobucket.com/albums/j404/CalamityJosh/Braintree-20121127-03486.jpg
http://i1084.photobucket.com/albums/j404/CalamityJosh/Braintree-20121127-03482.jpg
http://i1084.photobucket.com/albums/j404/CalamityJosh/Braintree-20121127-03480.jpg

Distance from inside to bracket:
http://i1084.photobucket.com/albums/j404/CalamityJosh/Braintree-20121127-03493.jpg
Width of bracket:
http://i1084.photobucket.com/albums/j404/CalamityJosh/Braintree-20121127-03492.jpg
Length of bracket:
http://i1084.photobucket.com/albums/j404/CalamityJosh/Braintree-20121127-03488.jpg
distance from the flat of the mudflap out to the bracket (determining angle)
http://i1084.photobucket.com/albums/j404/CalamityJosh/Braintree-20121127-03486.jpg

hope this is of some help?

and a final fitted picture:
http://i1084.photobucket.com/albums/j404/CalamityJosh/Braintree-20120910-02421.jpg