let missing

[sionrow]

hi, i got a let in my nova i had to take the inlet manifold off the other day to fix a pipe anyway cut a long story short, i put it all back together with new gasket but since then it take a wile to start when it does start it run and idels lovey and revs lovey but when it starts to get a bit warm it misses and it whant rev out then it cuts out and it whant start atall then, when it cools down it fine in till it get warm and does it all over agian. iv sprayed WD40 over the inlet and other pipes to find a air leak but no good. iv also changed one fuel injector.
so any help to fix it would be great.
THANKS.

[Novaloony]

Id say injector. change back to the one that was in there previously.
is the new one the same as the rest or from a different set?,

Try the old one back in there and see if the problems go.

[sionrow]

ok thanks ill try that, let you know

[GRUNT 16V]

Coolant temp sensor maybe ?? Or the wiring to it its located at the front in the thermostat housing

[sionrow]

iv changed the injector no joy so going to try the CTS and new plus and leads.
let you know.
thanks

[Paul]

Id recommend bcr8es plugs (rs turbo) gapped to 0.6

It may well be the cap. LETs dont like pattern caps, you're better off with an old bosch one.

[sionrow]

changed the CTS,plugs, leads and coil. is it worth me chaging the inlet gasket again?
any clue