View Full Version : Round port 1.4/6 inlet manifold for T40.
As above. I also have an irmscher 1.3 one if anyone interested in a swap? :)
Novasport
05-08-12, 08:23 PM
There is a project thread on here(Elgan's I think) showing a 1600 head ports being opened up to match the cathedral ports of a 1.3 manifold. Might be worth doing.
Novasport
05-08-12, 08:26 PM
Here you go....
http://www.pngclub.com/forum/showthread.php?187568-HEY-772Y-Project&highlight=
Ive started doing this to a e16se head so I can fit my Irmscher injection mani to it
Novasport
05-08-12, 08:52 PM
Does it lower the compression on a 1.3? Sorry to hijack your thread John.
Does it lower the compression on a 1.3? Sorry to hijack your thread John.
if you stuck a 1.6 head on a 1.3, then yes it would, but john is doing a c14se with the smaller chamber size
Novasport
05-08-12, 09:04 PM
Wasnt interested in John's engine, that is why I apologised. Edd is going forced induction so was curious.
Back on topic, whats your thoughts on adapting the head John or do you want to go round port still?
Chaps I'll add a pic to my c14se thread. :)
rednova
06-08-12, 10:19 PM
ive got an inlet to fit a 1600 if youre still wanting one? £60 posted?
Got one now, thankyou peeps :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.