View Full Version : 1.4 sr help
dose any one know where the wire from the choke on the carb gose to from the carb to...? help please
cann you be a little clearer?
Do you mean where does the wire from the choke go on the carb?
What carb is it?
On Weber goes on the left and throttle cable can go either side depending on mounting brackets...well mine does anyway...
The choke cable operates the carb air intake flap - just pull a lever on the side till that moves - then you know its the right ojne.
See haynes/carb instructions for setting up properly...
Ade
rgv_stu
02-08-03, 12:06 PM
if your on about the power wire that goes to the auto choke coil heater then its just a 12v feed from the ignition. black with yellow tracer iirc next to the alternator on the 1.2 1.3 1.4
Gazza14SR
02-08-03, 01:59 PM
if you go in the album and check out some pics that mike oxford uploaded then you will see on a 32/34 weber carb where the throttle linkage and chocke should be. Hope this helps.
there is a wire that comes from each side of the carb and it joins to a spade connector just want to know where i wire this wire to?
Ste_Nova
02-08-03, 04:46 PM
any switched live (black) but there should be a black/yellow wrapped up
Snowface
02-08-03, 05:18 PM
there is a wire that comes from each side of the carb and it joins to a spade connector just want to know where i wire this wire to?
it is explained here.
if your on about the power wire that goes to the auto choke coil heater then its just a 12v feed from the ignition. black with yellow tracer iirc next to the alternator on the 1.2 1.3 1.4
although i hoped that that wire by the alternator belt was for the Oil pressure sender.
Which wire is for the oil pressure?
If u have a manual choke conversoin on the 2e3 carb (like me :)), you don't need to connect up that wire.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.