View Full Version : fitting 14se head to nz bottom end
rookie_rod
31-07-12, 04:47 PM
does this work well, would prefer an se bottom end but funds are tight atm, it will be running on a 1300 inlet with 2e3 carb, as its for oval racing.
the round ports will need matching to the cathedral ones of the 1300 inlet. it should work ok, as the combustion chamber in the se head is quite small.
rookie_rod
31-07-12, 08:59 PM
just found a round port inlet, take it thats the 1400 1?
Depends what you rulebook says...
rookie_rod
31-07-12, 10:26 PM
rts/stansted euro rod mate, think they do say no interchnge of engines but if youve every had a car scrutineerd there before, ull relise they dont lift the bonnet..they only check ya brake light
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.