View Full Version : inline fuel locations on carb models
conza123
26-07-12, 12:15 PM
as above show me your stuff
look through my threads on my track car, any internal pics. basically from above the tank through between the seats up to the hole for the heater hose.
conza123
26-07-12, 03:01 PM
look through my threads on my track car, any internal pics. basically from above the tank through between the seats up to the hole for the heater hose.
have u got link as cant find and any others
http://www.pngclub.com/forum/showthread.php?186559-bumper-bar-removal-and-perspex/page2
You should see pics of the interior there if I have managed to paste a link?
conza123
26-07-12, 07:53 PM
Thats not what im looking for as its for my sr and i dont know where to stick it so it aint in the way or rattles
what are you on about, an inline fuel pump?? or fuel lines??
basically if you are still on carbs, the std mechanical one is fine.
conza123
27-07-12, 07:17 AM
what are you on about, an inline fuel pump?? or fuel lines??
basically if you are still on carbs, the std mechanical one is fine.
Sorry i missed out the work filter sorry
AndrewJenkins
27-07-12, 07:20 AM
i put my filter between the mechanical fuel pump and carb works a treat and easy to change
conza123
27-07-12, 09:29 AM
i put my filter between the mechanical fuel pump and carb works a treat and easy to change
have you got a picture
i used to put them on the inlet pipe before the pump, that way, the pump doesn't suck too much nasty stuff in, no pics as i've been efi since 1994, i simply cut the rubber hose a couple of inches above the nylon pipe & jubilee clipped it in place
AndrewJenkins
27-07-12, 06:02 PM
like mowgli says just cut pipe and insert filter ill get a pic over the weekend if needed
I also just cut the inlet pipe that goes between the inner wing and pump. I fit the cheap clear flters so I can see when it needs changed.
conza123
27-07-12, 11:29 PM
Have you made a bracket for filter as minw rattels abiut abit
mine were simply up in the air so they didn't hit anything.
AndrewJenkins
28-07-12, 09:08 AM
mine is held by the dip stick lol was going to make a bracket but that works lovely lol
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.