View Full Version : making a nova hatch into a van??
thought i'd put this in here
where can you get the rear window panels to make a hatch back nova into a nova van??
is it a case of a custom fabrication jobby :wtf:
cheers
1. remove windows & seals
2. get some metal sheet cut to about 8mm bigger than the glass in all directions.
3. get some seam sealer & pop rivets & get busy....
alt. method... paint or vinyl the windows
General Baxter
06-07-12, 09:17 PM
1 - go buy some van panels, and change them over lol
where would you get them from these days??? lol
novasrikev
06-07-12, 09:20 PM
where would you get them from these days??? lol
there on the shelf next to the hens teeth lol
i'll ring my rocking horse sh!t supplier to see if he's got any on his racks lol lol
Pistol Pete
06-07-12, 09:38 PM
Couldnt you just use the glass as a template and cut some metal "windows"?
you could, but if you used standard gauge sheet, it would rattle loose in the seals, the factory ones are slightly larger than the glass
iirc the original van panels are PITA to get out..
only asking for a mate...
surely using just some flat steel sheet would look gash cos its flat and making it convex would cost a considerable amount to do it rite
making it convex won't be an issue, the shape of the nova window frame isn't that complex a curve, so rivets will hold it to shape really easily.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.