View Full Version : quick shift
im after a quick shift for the gte anyone know where i can get one from ??
nevidred
04-06-12, 09:14 AM
make it yourself fella dead easy
make it yourself fella dead easy
can you give me some advice ???
Tiger13
04-06-12, 10:08 AM
I'd be interested in a *how to* on this + rep for anyone who does one lol
http://www.pngclub.com/forum/showthread.php?93294-*HOW-TO*-Rose-jointed-Linkage
its been in articles for ever.. Dar dit it cos he couldn't reach with the std one....lol lol lol
Jon_nova1
04-06-12, 10:14 AM
the pivot point on the rear gearbox mount, take 10MM off bar to the left hand side of it as you look into the engine bay then cut the right hand side and weld it in there, depending on how much you cut off and weld into place will depend on how short the shift is
Tiger13
04-06-12, 10:20 AM
+Rep for both of you, I missed that in the article section!, Not quite as simple as nevidred made it out to be, I dont even own a welder :-S
Jon_nova1
04-06-12, 10:27 AM
I've got two lol
PM me if you want it sorting, get feedback off Vinny-NOVA, I was down his last week putting new mounts and shock brackets on his rear beam;)
So would that fix work with any FWD vaux as their all basically the same?
I've got two lol
PM me if you want it sorting, get feedback off Vinny-NOVA, I was down his last week putting new mounts and shock brackets on his rear beam;)
i own a welder but i cnrt seem to get the idea of it all . how much would you charge to come over an do it ????
idea . father just look't at the page an side we got it all in the garge :D so starting it later on
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.