Corsa EPAS mounting confusion

[steg1970]

Chaps

When I bought my new shell the previous owner told me it had been converted to take the Corsa EPAS column. That was two years ago and since then I've managed to get myself confused.

I purchased a Corsa B column and controller etc ready to fit, but I don't know if the dash mounts are suitable. The bulkhead mount at the top of the coulumn has a bar welder to it to move the mounting position about 3 inches to the OS, Is this suitable for the Corsa B column or should it fit to the original mount without modification?

Are the Corsa B and C coulums installed differently?

Ta

[Iain]

Yeah I think the B and C column are quite different in their mounting.

If it's shifted 3 inches to the right it might be set up to use the Corsa double-UJ at the bottom which straightens up the column. Have you got that bit too?

[steg1970]

Yeah, got all bits.

Also will the bottom of the Corsa double UJ fit the Nova rack without modification?

[cossienova]

Interested in doing this myself. Is there a guide or anything on here?

[Iain]

Seems to Steg, yeah. Slide it over the pinion and do the bolt up and it seems to clamp it on fine.

[Mark]

B and C are very different, B fits without modification, C does not.