how hard is it

[paddy quinn]

i got a set of mk3 dails other day off a gm low blow has the rev counter but how hard is it to wire into a nova td loom as i hate the nova speedo the lighting is p1ss poor

[brainsnova]

Most wires will probs be the same like how the Astra gte digi pretty much matches up.

[Nova_Tek]

SHouldn't be too hard. Have you got the connector from the Atra loom for it? YOu can just splice wires to it. Harder is fitting the dials into the dash...almost impossible on the MK1 doable on the MK2.

[paddy quinn]

yeah got both connectors out the astra think the second 1 is only for none vital info

[Jack]

Dials like these?

http://i13.photobucket.com/albums/a266/razorjack/Cars/Project%20Ghey/12102008764.jpg

[paddy quinn]

yeah jack just the td ones

[Jack]

This is how mine is wired in:

http://i13.photobucket.com/albums/a266/razorjack/Cars/cav-nova.gif

You'll also need to cut out part of the steering column mount, the air ducting and dial cowl.

[Nova_Tek]

Are those dials in the loon Nova?

[Jack]

Yarp

[paddy quinn]

http://i964.photobucket.com/albums/ae121/paddyq85/30042012163.jpg

[Benn]

I was about to say, wiring is easy, it's the amount you cut up the dash that's the prob... Rich did a guide some where...

[Southie]

Here's the how to Benn mentioned README (http://www.pngclub.com/forum/showthread.php?63363-*HOW-TO*-Fit-Cav-Calibra-clocks-into-a-Nova&)