View Full Version : how hard is it
paddy quinn
29-04-12, 05:29 PM
i got a set of mk3 dails other day off a gm low blow has the rev counter but how hard is it to wire into a nova td loom as i hate the nova speedo the lighting is p1ss poor
brainsnova
29-04-12, 05:58 PM
Most wires will probs be the same like how the Astra gte digi pretty much matches up.
Nova_Tek
29-04-12, 06:21 PM
SHouldn't be too hard. Have you got the connector from the Atra loom for it? YOu can just splice wires to it. Harder is fitting the dials into the dash...almost impossible on the MK1 doable on the MK2.
paddy quinn
29-04-12, 08:35 PM
yeah got both connectors out the astra think the second 1 is only for none vital info
Dials like these?
http://i13.photobucket.com/albums/a266/razorjack/Cars/Project%20Ghey/12102008764.jpg
paddy quinn
29-04-12, 09:33 PM
yeah jack just the td ones
This is how mine is wired in:
http://i13.photobucket.com/albums/a266/razorjack/Cars/cav-nova.gif
You'll also need to cut out part of the steering column mount, the air ducting and dial cowl.
Nova_Tek
29-04-12, 10:49 PM
Are those dials in the loon Nova?
paddy quinn
01-05-12, 01:13 AM
http://i964.photobucket.com/albums/ae121/paddyq85/30042012163.jpg
I was about to say, wiring is easy, it's the amount you cut up the dash that's the prob... Rich did a guide some where...
Southie
01-05-12, 08:02 AM
Here's the how to Benn mentioned README (http://www.pngclub.com/forum/showthread.php?63363-*HOW-TO*-Fit-Cav-Calibra-clocks-into-a-Nova&)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.