View Full Version : Corsa gear selecter
mcgee.m
20-04-12, 08:15 AM
As above is it hard to fit this to a nova any one got pics I've this done
Pretty much same as any other, cut, straighten, weld. Alls you are aiming to do is make a straight link between shifter and linkage.
ive just fitted one to mine, mark on the tunnel in the centre of the nova shifter where the nova one sits approx, then remove it then place it next to the corsa one cut 3inch off each end of both shifters and weld the nova female end to the corsa selector rod job done!
I don't see the point in this mod tbh unless you're running a massive exhaust and need clearance under the car
BRoadGhost
21-04-12, 10:04 PM
Two other improvements could be raising the shifter closer to the driver and a more direct feel, even retaining plastic bushes.
is there any direct shifter setup where you can still use a center console?
BRoadGhost
21-04-12, 10:45 PM
Yes, the one where you drill a hole through the ashtray in the dash :)
lol I thought it sounded like one of those nice but impossible things lol
mcgee.m
23-04-12, 08:00 AM
Thanks for info
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.