View Full Version : Anyone used tx autosport let con rods?
turbo-boy
17-04-12, 07:06 PM
Seen tx autosport c20let forge steel conrods for sale on eBay , was wanting to no if anyone has used them and what there views were on them as I think they where priced well,
turbo-boy
17-04-12, 09:27 PM
Are they china specials I take it?
No!
Why No! I have chinese rods in my turbo engine? As do many others? Id trust chinese rods over a DIY turbo rebuild all day.
because if you know where to look you can get proper rods for not much more, bare in mind if a rod lets go your engine is scrap so an extra £100 is cheap in the long run
im willing to bet 90% of all the steel is from the same sources anyway.
turbo-boy
18-04-12, 01:00 PM
Can get the tx rods of eBay for around £300, when compared to other roads they use the same material and the and all other specs
BRoadGhost
18-04-12, 03:28 PM
Why anyone would want I beam design & not H is beyond me
Old man Jimbo
18-04-12, 04:57 PM
Can get the tx rods of eBay for around £300, when compared to other roads they use the same material and the and all other specs
For the same money you can get Williams H section rods. It's a no brainer! If I was allowed I post a link for a set that end in a few hours sat a £200 with no bids!
Them TX ones look shat.
turbo-boy
18-04-12, 05:33 PM
Send me the link lol
I thought they could be bought off sbs for a shade more
Old man Jimbo
18-04-12, 06:01 PM
Send me the link lol
Done.
Still waiting to hear what 'proper' rods you're going to sell me for £350 delivered?
turbo-boy
18-04-12, 10:18 PM
Cheers old man jimbo got a Bargin there,
Still waiting to hear what 'proper' rods you're going to sell me for £350 delivered?
if i say im breaking the rules lol it had already been said where in this thread though
Chap on migweb from Lithuania does them for £250 (come with ARPs too), no one seems to have a failure yet?
I would trust cheap steel rods over standards, but wouldn't trust them in a high power spec.
BRoadGhost
18-04-12, 10:49 PM
I managed to source a set for just over that delivered, after bending rods on cylinders 1 & 3.
turbo-boy
19-04-12, 08:52 AM
I only aim for 300bhp and hav read about them
William motor sport Rods and people like them
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.