View Full Version : nova E16se intake temp switch ,
nova gem 1970
16-04-12, 08:15 PM
wanted an intake temp switch for a E16se engine ,must be a 2 wire type & be the square plug end type ,cheers.:thumb:
ok, ya got me.... i've never heard of this switch, and i have been messing with e16se's for a good while.. are you sure its not the coolant temp switch?
nova gem 1970
16-04-12, 08:38 PM
ive looked in the haynes manual ,its bolted in the small alloy body that goes on the back of the inlet ,its the body that water passes through, theres a sensor that points towards the passenger side im after
definitely CTS (coolant temp switch)
just ring a local factors & ask for a square plug type cts for a vauxhall
nova gem 1970
16-04-12, 08:47 PM
my coolant temp switch is on the side of the head under the dizzy ,if youve got a haynes manual on novas , its on page 13.34 supplement top of the lhs of the page
and you have the later type head then.. i got a replacement head with the round type CTS under the dizzy,... so i left it in to plug the hole.
my engine is a really early one & has the block on the back of the inlet manifold with the water pipes to it, & it has a square type cts exactly where you describe...
nova gem 1970
16-04-12, 09:14 PM
cheers for the much needed info ;)
nova gem 1970
16-04-12, 09:26 PM
ive just taken the switch out & it doesnt even go into any water related jackets ,it just screws into the inlet ,gm part number 267063 (17*-12*)
ok, i'll have a look at mine tomorrow
nova gem 1970
16-04-12, 10:40 PM
thank you :)
best off buying new than second hand with that sort of stuff, you know it wont break again
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.