View Full Version : HELP X16XE cutting out, immobiliser poroblem? VSS?
maddogdaz666
27-03-12, 07:34 PM
ive fitted an X16XE from a tigra into the astra Mk2.
Ive used the full loom ECU Chip and transponder from the tigra and followed the wiring diagrams on her to wire it in too.
It fires up nut then cuts out after a second or 2
Can anyone help
I havnt fitted a VSS yet, im going to try and get one tomorrow, but i thought it should fire up without it? or am i wrong?:tard:
jackerts
27-03-12, 08:17 PM
will run without VSS will just cut out dropping to idle (at junctions etc)
are you using the key with the chip fitted? or holding it close to the transponder?
maddogdaz666
27-03-12, 08:30 PM
chips taped to the astra key. its sat on axel stands with no shafts in at the mo as ive been painting the suspention and inner aches. could it be that? as the diff does spin slightly
jackerts
27-03-12, 08:46 PM
sounds like immobiliser to me mate have you got eml wired up? it will flash if no signal is been recieved iirc
maddogdaz666
27-03-12, 08:58 PM
no as theres no EML on the standard clocks, ive got a digi dash i might wire that up tmoz and get a tranducer/VSS for that so it will all be wired up. Just hope i can find one tmoz.
jackerts
27-03-12, 09:51 PM
No choke light on the clocks? any spare warning light will do the job tbh pal. Drop me a text if your having trouble and i will come lend a hand, I've done a couple of nova x16/x14xe's and never had any bother so it can't be anything major
maddogdaz666
27-03-12, 10:00 PM
Cheers bud I will do.
got a non-immobiliser ecu that i would get rid of cheap if your still having problems?
Nova Baz
28-03-12, 08:47 PM
tape the chip to transponder and try that. that's how i've got mine set up in my nova and it fired up first time.
Get the ecu light wire onto a bulb and see if its flashing when you switch the ignition on.
Definently sounds like an immobiliser issue
maddogdaz666
29-03-12, 12:11 PM
got a non-immobiliser ecu that i would get rid of cheap if your still having problems?
An x16xe ecu? Cos the c16 won't plug n play
maddogdaz666
29-03-12, 12:14 PM
I've had the chip taped to the transponder and taped to the key and it made no difference, I've also swapped the red n blue wires round on the transponder and it's
Made no difference
An x16xe ecu? Cos the c16 won't plug n play
yeah its a early x16xe ecu
maddogdaz666
29-03-12, 10:46 PM
How much u wanting for it
maddogdaz666
31-03-12, 11:52 AM
I've just untapped the chip and held it in position ish with my thumb and it fired up!! I'm off to get a key cut that will hold the chip inside :) looks like I'm off to the mats in the Astra now yay!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.