cheap mesh?

[ashman]

Does anyone know where you can buy cheap mesh? ( cheaper than halfords!!! ). i've looked around a couple of DIY stores but can only find sh!tty chicken wire! any ideas?

cheers Luke

[DUNOVA.]

I got my mesh from a building site!The mesh that plasterers use try a builders merchants.mine looks pretty good have a look my cars in the feature forum

[epo]

i thought the stuff from halford wernt to badly priced paid 20 notes for mine did me grill and had a bit left over

[greg00uk]

go to motor world, payed ?20 for a massive sheet.

already done my grille twice, and a few intakes and got loads left. comes in aluminium, red and blue :lol:

[thesparky]

try your local wicks diy store they had some different types in all round the ?5.00 mark

[Gazza14SR]

B&Q do good mesh too at lower prices than halfords/motorworld etc

[14sr]

i paid ?9 for a big bit from xs motorsport stall at knockhill at the weekend looks the dogs danglys think it was made by a company called vr something or other

cheers stuarty

[Tazzy]

i paid a tenner for some quality mesh from midlands performance centre in walsall!, about a metre long!

but i prefer the metle sheeting with the holes in it, it looks more modern, and different!

[ade]

B&Q - theres usually a section where you can get fancy mesh, metals and rods. Its usually the stuff used for designing radiator covers - You can actually pick up sheets of that aluminium flooring with the crossed tread design in it!

prices vary - I got a decent piece for ?11. you need to spray it though it it rusts

[Nova-Boy]

I have got really fine stainless mesh rather than the big stuff that builders use cos flies and moths can fit through the gaps

I got a stip from work for nothing!

?20 a good price! Are you mad?? You only need about 6" by 30" to do a grille!

Stainless stuff is nice and shiney and wont rust!

[?Marty?]

I paid ?36 for a 60cm by 100cm piece of alloy with holes drilled into it. Bought four of 'em.

Bollocks.

[privatepie]

the plastering stuf is called EML (expanded metal lathe)