View Full Version : Bolting in roll cage does anyone use sleeves?
Hi chaps was talking to a lad about bolting my roll cage in and seems to think i should use sleeves as the bolt will pull through even with my 3mm spreader plates?
phunkynova
20-02-12, 06:43 PM
You should have spreader plates on the inside and small ones on the outside the outside ones should be at lease the same size as you cage foot
Washers are also your friends.
Washers are also your friends.
Ye mate obviously gona use washers lol just my mate was convinced of sleves but never seen any fitted on here?
autoworksnovasport
20-02-12, 10:32 PM
sleeves wont let you bolt it in tight as you will only tighten onto the sleeve not the body
BRoadGhost
20-02-12, 10:46 PM
Barry bolt-in
Sleeves get used on bolt in cages, where the tubes join together. Slips over the tubes and bolts go through sleeve and tube. I think your mate's a bit confused
Barry bolt-in
This however is correct. Bolt in cages are shi.......... poo :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.