Nova panels

[spear_]

can anyone tell me the best place to get panels for my 91 nova really need n/s rear inner wing thanx
john

[blue_peg_16v]

You will be lucky for that part you will probably have to fabricate it yourself rear inners are very hard to find

[spear_]

what about other panels?????

[bazil]

How deep are your pockets?

[spear_]

How deep are your pockets?
i hope deep enough for some panels lol

[spear_]

So does anyone know of any shops that have panels?

[christurboo]

aoutopanels got me 2 sills overnight quite cheap

[bazil]

How do you mean rear inner wings? Can a inner repair section not work?

[spear_]

this is what i have hope u can help with panel also stock of front cross member
http://i176.photobucket.com/albums/w171/Spear_3108/chassi.jpg

[Novasport]

Inner tubs are not easy to get hold of, you will be better off remaking it from plate.
Mk2's seem to rot for the fun of it! Is the chassis leg OK?

[spear_]

think so brother in-law going to weld it if leg is no good should i fix or is there a replacement legs available

[Novasport]

Legs are impossible to find new, been NLS for years.

[nova_saloon]

Just find the same gauge metal, get a hammer and start whacking, everyones doing it :)

[G-nova]

Carz2.co.uk are a good place to try

[bazil]

Just cut out the rot, get good quality sheet steel and cut to shape, trying to replace that panel without removing section of the floor would be near impossable, also it hold the mount for the rear seatbelt, it is situated in a cavity between the chassis leg and boot floor.

Seriously check the chassis leg for structural strength as the rear beam mounts are quite important

[spear_]

even if chassis leg needs work i assume they are fixable with a good welder and a bit of patients apart from rust anything i should be looking out for?

[bazil]

Alignment, if you remove the leg or mount you'll have to make sure it's spot on when reattached, I mean mm perfect.

[Edd]

They never bothered getting it right at the factory tho lol

My rear beam must be about 5mm out ffs lol

[Balley]

This is how I did mine :)

https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-snc7/383296_10150380651193775_718778774_8431399_1820244 148_n.jpg

https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-snc7/382173_10150380855288775_718778774_8432448_1531296 871_n.jpg

https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-ash4/310970_10150380652238775_718778774_8431407_3794810 03_n.jpg

https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-ash4/315939_10150380652588775_718778774_8431411_8659665 67_n.jpg

https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-snc7/382914_10150382506768775_718778774_8437652_9084121 90_n.jpg

[spear_]

thanks printed and ready for the cutting lol