View Full Version : Crank sensor test...
Mucker_TD
10-01-12, 05:10 PM
Is there a simple way to test if your crank sensor is at fault?
Engine in question is c20xe early type
Unplug sensor connector,using a digital volt ohm meter set on ac volts position.Connect the leads to the two pins in the connector of the crank sensor.Then have a helper crank engine over.You should see ac voltage,if not,then your crank sensor is bad.
Mucker_TD
10-01-12, 06:58 PM
^^^ Top bloke, much appreciated! ^^^
Bear in mind this will only confirm the sensor wiring is ok and that the sensor is capable of producing a signal - theres no guarantee the signal is correct. You would need an oscilloscope to truly check it was ok.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.