Mk1 bumper fixing bracket holes.

[strcnova]

Right need help please.

I have a mk2 shell and trying to fit a mk1 rear bumper.
the holes on the car are to small 6mm holes on the leading edge of the panel but to fit the mk1 bumper the fitting holes are different.
Can some one please give exact postion of the holes to fit the mounting bracket for the bumper and even photo's aswell.

Cheers for the help.

[bazil]

Personally I'd put the slides on the bumper, bolt the bumper on, place the bumper sides where you want it to sit, mark along the top edge of the mount, remove bumper line up mount against said mark, mark holes drill then bolt on,

The last thing you want to do is get measurements wrong,


Edit, forgot you were only in EK if your about next weekend you can come over to mine and measure my mk1 shell if you want, that way you can rely on your own measuring?

[strcnova]

Bazil i will take you up on that offer. Your right if i get it wrong its my fault. i will bring pen and paper and a tape measure.

Cheers

[bazil]

I'll send you my number by pm