View Full Version : brake servo pipe
im connecting up my servo pipe to my bogg bros inlet manifold and ive had to buy a bit pipe to get it to fit
the small valve looking thing on the standard pipe is this needed? theres no take-offs from it it just sits in line with the pipe
Its a one way valve so yes :)
Out of interest what pipe did you find to fit it? I've had to use a bit of silicone hose but was reading the hard plastic pipe is better for this.
ah well then just have to leave it
another quick question about 1 way valves, is it worth fitting on onto the fuel line? im running r1 carbs and have seen you can get them for the fuel line
Out of interest what pipe did you find to fit it? I've had to use a bit of silicone hose but was reading the hard plastic pipe is better for this.
silicone hose from ebay as well, i suppose harder pipe would be better but silicone was easier to get
Swedge, You could fit a one way valve in the line but at a guess your fuel pump would have one any way, Maybe a good idea but in my eyes if its fine at the minute then don't bother as its only something else that could go wrong.
Dan
you can buy vacuum hose from decent hose suppliers, it has a wire strengthening layer & the inner rubber won't collapse.. you used to be able to get it for the opel mantas
Fuel pipe(for injection engine) FTW
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.