View Full Version : tx crank pully
torquey
13-12-11, 07:18 PM
got my tx single v crank pully but noticed that a couple of holes dont line up properly anyone one else had this. so gonna have to drill them out slightly not impressed. also no mark for timing on it why dont tx put marking on things the vernier has no marks for setting up either.:mad:
Keep rotating it around and it will line up :thumb:
torquey
13-12-11, 07:25 PM
right will give it ago was doin it in the dark bein inpatient cheers
As Mike says, holes are offset so it only fits on one way
I agree the lack of timing mark is quite annoying, I tried to bolt mine to the old pulley and draw a timing mark on it...
torquey
13-12-11, 08:00 PM
right cheers yeh its annoying thing is havnt got the old pully
i had the same problem with mine me an a mate put the pully on span it round a few times an the holes wouldnt line up we sorted it in the end and drilled the holes slightly bigger so we could get the bolts in.
that was the last resort drilling it like i said we did spin it it round a good few times
can't you just send it back if it doesn't fit right?
i had this problme fitting mine on my cav drove me nuts aye f lol
but as others said keep turning it in will line up :thumb:
just how many times can you turn it round if it doesn't fit???
answer: once..
what do they charge for this pulley? cos if i was buying something to spin at 7000rpm, i'd expect it to be right first time.
even the standered pully only goes one way
can turn it 6 times as 6 holes lol
its a crank pulley, so you can only rotate it thru 360 degrees, before you get back to where you started
its a crank pulley, so you can only rotate it thru 360 degrees, before you get back to where you started
This.
Mine went on perfectly. But I knew the holes were offset from the start lol
didnt mean turn it 6 times, meant only 6 chance's to line it up lol
torquey
01-01-12, 08:56 PM
ive done it now cheers
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.