Complete c16xe engine + box, loom, ecu, ect.

[Phil_d]

Have the remains of my c16xe for sale, bare engine is sold, i have still for sale
Gearbox f15 i believe £30 collected
Lower c16xe inlet £15 posted
Upper Plastic inlet manifold £10 SOLD
Exhaust Manifold £15 posted
Injectors and fuel rail £20 posted
Throttle body £15 posted
Induction pipe(throttle body to afm) £5 posted
AFM £15 posted
Alternator £20 posted
Short fan belt for conversion £5 posted
Plastic water pipe that comes from the water pump(brand new cost me £36 and did 50 miles) £10 posted
Starter Motor £15 posted
ECU £25 posted
Full Wiring loom very good condition £25 posted
Blue engine cover £10 posted
x16xe head complete with valves and cams, would advise a skim to be on the safe side £25 collected

Open to offers on everything as its no longer any good to me!

Also got a c20xe for sale, near enough bare, comes with inlet, single v alternator, oil cooler, dizzy, idle control valve, just had new water pump and cambelt. £200 SOLD

Probably some more when i can get chance to sort through it.
http://i1085.photobucket.com/albums/j438/phildgsxr/IMAG0016.jpg

http://i1085.photobucket.com/albums/j438/phildgsxr/DSC00306.jpg


Also can deliver at cost (reasonable distances)

[mk1nova_rich]

If you decide to split, I'd be interested in the loom if its in good nick

[Phil_d]

Looms in good nick pal, if i get any offers on other bits i may decide to sell in bits, just thought if i sold it all with everything needed for a conversion, someone may be interested just to drop it straight in. All mounts included also if fitting to a 1.0l.

[Phil_d]

Bump open to offers could do with it gone

[Phil_d]

Bump last chance before it goes on the bay tomorrow!

[christian1992]

Hi mate how much for the ecu mine caught fire lol

[Phil_d]

Its on the bay as a complete engine with ecu and everything, if it dosent sell i may consider breaking.

[Phil_d]

Back up for sale, was sold but bloke never turned up(no-one off here :)) open to offers

[Phil_d]

Bump open to offers

[Phil_d]

bump

[Nova_Tek]

Are the shafts 22 spline GTE? Willing to split if it is?

[Phil_d]

I have a pair of shafts that came from the corsa gsi donor and a pair of 1.0l shafts, i used short gsi shaft and long 1.0l shaft, hope this helps.

[Phil_d]

Updated now breaking!

[Phil_d]

updated! bump

[boyd_1989]

Is the ecu standard limit or raised?

[Phil_d]

To be honest im not sure, i bought a chaved up corsa gsi, and stripped it, i have no idea of the history. Was told it may have had hi lift cams in but i dont think it did.

[boyd_1989]

Ok mate no worries, how much was you after for the ecu then?

[Phil_d]

ECU £25 posted pal

[Phil_d]

Bump thread updated!!

[johnd]

pm-ed lad chears